Single Phase DC Current Transducer NB-DI1C0-□9KD
DI1B0-□9KD is a DC Current Transducer that detects DC current in a wire, and generates a signal proportional to that current. The generated signal could be analog voltage(0-5V dc,0-10V dc) or current( 0-20mA,4-20mA) output. The generated signal can be then used to display the measured current in an ammeter, or can be stored for further analysis in a data acquisition system, or can be used for the purpose of control.
Specification
v Accuracy：Class 1.0
v Power supply：220Vac（Optional）
v Input range：DC 10～600A（Customizeable）
v Output：0-5V、0-10V、0-20mA、4-20mA（Customizeable）
v Operating termperature：-10℃～+60℃
v Load Capacity：Voltage for output ≥2KΩ；Current for output ≤250Ω
v Static power consumption：≤0.3W
v Rated power consumption：≤0.7W
v Load of Isolation Voltage：DC 2500V
v Response time：≤200ms
v Thermal drift：≤500PPm/℃
v Lightning surge Immunity：Power-supply end2000V，output end 10000A，Input end 500V
v Case style：K
v Case material：ABS flame retardant
v Mounting: 35mm DIN Rail or screw
Wiring Diagram
Current Hole-thru Input；Terminals 8 and 12 are for output；Terminals 10 and 11 are for power supply; Terminal 12 is GND for both output and power supply.
Instruction
v Ensure correct wiring the terminals to avoid possible damage to the device; The mounting gap between two devices should be not less than 5mm. |
v In magnetic fields, the power lines should be in good conditions, and shieldings should be taken against the magnetic interference to the device. |
v Proper measures should be taken agaist the lighting if exposed into the outdoor environment, though this device has lightning protection ability. |
v Do not take the device apart. |
v Please keep the device cool and dry ,and store it away from humidity or high temperature above 85℃. |
